Sometimes for check of a corner washed down use plumbs and the joiner's calibrated levels. The level laid on the ground detail surface on a gleam will show existence of failures and humps. More exact devices, than the hour indicator, in joiner's business are practically not used.
One of the most complex challenges in joiner's business cutting of a running carving, both in the block, and on a cylindrical surface is considered. In such situation it is necessary to resort to use of a joiner's type-setting die.
Modern joiner's processing is almost impossible without use of huge number of auxiliary adaptations and devices.
All listed adaptations are used for fixing of preparation on a joiner's workbench or a desktop. In joiner's business not to do without special stones and adaptations for sharpening of the cutting edge of edges, drills, knives.
If the usual knife still can try to be ground manually, the slightest deviation of a form or a corner of the cutting edge means marriage in work for a joiner's arsenal. Practically all joiner's tool is sharpened only on the electric sharpened or the special adaptation with a set of stones.
For fast planing it is possible to use a joiner's electroplane, enough it is only correct to adjust a departure of an edge of an edge and speed of giving of the tool.
For cutting of round and ellipse grooves and cavities special knives and the tool with the curved cutting edge – tatyanka are used. On the basic end of a joiner's knife the huge wooden handle in the form of a round knob settles down.
Together with a chisel the joiner's hammer, or a kiyanka is used. A chisel it is possible to cut out a groove, to correct a thorn or to cut a bar end face. In fact, the chisel in joiner's business is also important, as a screw-driver in electric installation work.