The first adaptation will help to make spent on drink the 13 mm in depth.
When legs were already ready, I understood that the board cm bought by me at a bargain 5×15 not the best quality. The majority of them had the numerous zazubrinka left rollers of the mechanisms moving timber on sawmill. To remove them, I used the face plane (the truth, I realize now that it was necessary to cut off simply the defective party on the detachable machine).
Frames are ready, now it is possible to concentrate the attention on legs. For production of each leg having the G-shaped form 5×10 cm and 5×15 cm of a board connect at an angle 90 degrees. The distance between the screws fastening them twisted at an angle is important though especially does not influence design durability. It is simple to arrange these screws it is necessary so that subsequently they appeared the hidden ladder steps.
They are pasted and fastened to walls of frames from the inside.
I made these two adaptations for the only purpose – to show you that for implementation of this project there is at all no need to get expensive tools (the lentochnopilny machine or the detachable machine with a table). All necessary cuts can be made a simple circular saw. Actually, it was simply demonstration of opportunities, I made the rest of cuts on the ends of levels, using the tape saw.
Whetstones section 5×5 are necessary for maintenance of a river bottom see. However, for me was cheaper to buy 5×10 cm whetstones and to make of them 55 cm of preparation.
Usually removable rack bottom make of levels 2.5×10 cm or 2.5×15 see. For single mattresses such sizes can be considered optimum. But I managed to buy 5×10 cm of a board cheaper for running meter, than 2.5×10 see.